BOGE SRHV Booster Compressors are the most accurate way to pressurize compressed air in the range of 5 – 10 bar to pressurize up to 40 bar. They are the most preferred booster compressors in the World. They are unrivaled with their smart touch focus control panel and low maintenance cost.
Everything is simply under control
Even if it is supplied in a separate control cabinet for wall mounting – the focus control 2.0 is the control centre for these models. It continuously monitors primary and final pressure, delivery volume and pressure level. Its warning and fault management means the machine is switched off when maximum pressure is reached or if it falls below the primary pressure, and all locally saved events can be read and analysed at any time.
Excellent efficiency thanks to high level specifications
A plethora of individual measures ensures the exemplary efficiency of these models. The minimisation of the clearance in the cylinder plays a central part, whereby the volumetric efficiency can be increased considerably. However, the largest gain in efficiency comes from the principle of increasing the pressure from an existing network: unnecessary higher compression is avoided, and the energy intake from the combination of screw compressor / booster remains considerably lower than with atmospheric 2-stage or 3-stage compression by piston compressors.
Quality down to the finest detail
All components are developed and installed by BOGE in Bielefeld; for it is only
when you have full control over production that high performance can be
combined with a long life cycle. Only high-quality materials are used, and the
modern production processes ensure minimum tolerances – the precondition
for efficient, low-wear operation.
Extremely durable even in continuous operation
These compressors are truly hard-wearing and they know no limitations in their duty cycle. The reasons for this are to do with the design: the low average piston speed of 3 m/s (by comparison: depending on the speed, diesel motors run at around 7–15 m/s) reduces the heat retention of the components and thereby lessens stresses and wear. Everything designed to enable low-maintenance, cost-saving operation and longer service life.
Higher-level system management
The focus control 2.0 takes over the entire monitoring of primary and final pressures and controls up to four connected compressors in base load change as required: Whether the most powerful booster is always switched on first or the oldest booster is always switched on last, or whether they are all used to capacity equally so that maintenance can be carried out at the same time – modular control provides this degree of freedom. Redundancy is thus also ensured very simply.
It all works like clockwork
If you use only BOGE original spare parts, you will benefit from the manufacturer’s technological advantages for years. You can remain confident that your BOGE compressor will continue to demonstrate all its positive characteristics and perform to the full even after repa
40 Bar
- The Most Rational Solution To Increase Nitrogen Gas Or Air Pressure
- Lubricating Oil Level Indicator
- Focus PLC Control Board with Star-Delta Contactor
- Low Speed, Quiet Operation
- Design for 24/7 Operation
